Note: Make sure that the empty add-in card slot has the filler panel installed.
4. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
Removing and Installing the Processor Air Duct
Always operate your server server system with the processor air duct in place. The air duct
is required for proper airflow within the server system.
For instructions on adding or replacing a processor, first remove the processor air duct,
and then see your server board user guide for instructions on processor installations and
removals. Return to these instructions to reinstall the processor air duct after installing
your processor and heatsink.
Removing the Processor Air Duct
To remove the processor air duct, follow these steps:
1. Remove the PCI riser assembly. For instructions, see
Assembly" on page
2. Lift the processor air duct from its location over the two processor sockets.
46
Riser Connector
B
Figure 31. Removing a Full-height Add-In Card
41.
AF002854
42.
"Removing the PCI Riser
®
Intel
Server System SR1600UR Service Guide
A