Chapter 4. Installing Options; Installation Guidelines; System Reliability Guidelines; Handling Static-Sensitive Devices - IBM 8835 - Eserver 325 - 1 GB RAM Maintenance And Troubleshooting Manual

Chapter 4. Installing options

This chapter provides detailed instructions for installing hardware options in your
server.

Installation guidelines

Before you begin installing options in your server, read the following information:
v Read "Safety information" on page 101 and the guidelines in "Handling
v Make sure that you have an adequate number of properly grounded electrical
v Back up all important data before you make changes to disk drives.
v Have a small Phillips screwdriver available.
v For a list of supported options for your server, go to

System reliability guidelines

To help ensure proper system cooling and system reliability, make sure that:
v Each of the drive bays has a drive or a filler panel and electromagnetic
v There is adequate space around the server to allow the server cooling system to
v You have followed the cabling instructions that come with optional adapters.
v You have replaced a failed fan as soon as possible.

Handling static-sensitive devices

Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces
© Copyright IBM Corp. 2002, 2003
static-sensitive devices." This information will help you work safely with your
server and options.
outlets for your server, monitor, and other devices that you will connect to the
server.
http://www.ibm.com/pc/us/compat/.
compatibility (EMC) shield installed in it.
work properly. See the documentation that comes with the rack.
Static electricity can damage electronic devices, including your server.
you.
metal part of the server for at least 2 seconds. This drains static electricity from
the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on your server cover or on
a metal surface.
indoor humidity and increases static electricity.
25