IBM 8835 - Eserver 325 - 1 GB RAM Maintenance And Troubleshooting Manual page 43

b. Lift and place the power-cord module out of the server as far as the power
supply cable permits.
9. Install the adapter:
Attention: When you handle static-sensitive devices, take precautions to
avoid damage from static electricity. For information about handling these
devices, see "Handling static-sensitive devices" on page 25.
a. Remove the adapter from the static-protective package and set any
jumpers or switches on the adapter as directed by the adapter
manufacturer. If you are installing a full-length adapter, you might have to
remove a plastic bracket secured to the adapter with 2 screws before
installing the adapter.
Attention: When you install an adapter, ensure that the adapter is
correctly seated in the connector before you turn on the server. Improperly
seated adapters might cause damage to the system board, the riser card
for slot 1, or the adapter.
b. If you are installing an adapter in PCI-X slot 1, attach the PCI riser card to
the adapter. Reinstall the PCI riser card with the adapter already attached
to the PCI riser card.
c. Grasp the adapter by its top edge or upper corners, align it with the
connector, and press it firmly into the connector.
10. Slide the expansion-slot clip toward the server until it snaps into place to
secure the adapter in the adapter slot.
11. Connect any internal cables to the adapter. See the instructions that come with
the adapter for details.
Attention: Ensure that the cables do not block the flow of air from the fans.
12. If you removed the power-cord module to install the adapter in PCI-X slot 2,
install the module by reversing the procedure in step 8a on page 32.. Ensure
that the alignment tab is fully seated in the slot on the side of the server.
13. If you installed the adapter in PCI-X slot 1, secure the adapter by flexing the
adapter-retention bracket toward the front of the server and inserting the front
corners of the adapter into the recesses in the latch.
14. Perform any configuration tasks required for the adapter.
Note: If you installed a Remote Supervisor Adapter II:
a. Refer to the documentation provided with the Remote Supervisor
Adapter II for information about installing the Remote Supervisor
Adapter II firmware and configuring the adapter.
b. After you initially configure the adapter, you should create a backup
copy of it so that if you need to replace the adapter in the future,
you can restore the configuration and resume normal operation
more quickly.
15. If you have other options to install, install them now. Otherwise, go to
"Completing the installation" on page 47.
Chapter 4. Installing options
33