5. Locate the battery (connector BAT1) on the system board.
Microprocessor 1
(U1)
6. Remove the battery:
a. Use one finger to press on the tab securing the battery to its housing.
b. Use one finger to slide the battery up and out from its socket.
7. Insert the new battery:
a. Hold the battery so that the larger side is facing up.
b. Place the battery into its socket, and press down until it snaps into place.
8. Put the PCI adapter shield back into place.
9. Reinstall the server cover, and connect the cables.
10. Turn on the server.
11. Start the Configuration/Setup Utility program and set configuration parameters.
v Set the system date and time.
PCI-X slot 1 (PCIX1)
PCI-X slot 2 (PCIX2)
Remote Supervisor
Adapter II (JMGT1)
Battery (BAT1)
Microprocessor 2 (U2)
Chapter 4. Installing options
43