Operator Information Card - IBM 8835 - Eserver 325 - 1 GB RAM Maintenance And Troubleshooting Manual

Operator information card

Complete the following steps to remove the operator information card. This
component is located in the front of the server.
Note:
1. Turn off the server.
2. Disconnect all power cords and external cables from the back of the server;
3. Remove the server cover and bezel (see "Removing the cover and bezel" on
4. Remove the hard disk drive that is in the right-hand bay, if any (see "Working
5. Disconnect the operator information card cables from the system board.
6. Gently pull the operator information card forward until it disengages from the
7. Disconnect the cables from the rear of the operator information card.
To replace the operator information card, connect the two cables to the rear of the
card and slide it under the tabs on the chassis until it is firmly anchored.
58 Eserver 325 Type 8835: Hardware Maintenance Manual and Troubleshooting Guide
v Read "Installation guidelines" on page 25.
v Read the safety notices at "Safety information" on page 101.
v Read "Handling static-sensitive devices" on page 25.
then, remove the server from the rack.
page 27).
with a hard disk drive" on page 34).
Note: The illustrations in this publication might differ slightly from your
hardware.
two tabs on the chassis, making sure that any cables that are pulled slide
smoothly.
Tabs
Operator
information card