Internal Drive Bays - IBM 8671 - Eserver xSeries 235 Maintenance And Troubleshooting Manual

Internal drive bays

Internal drives are installed in bays.
Tower model
Hot-swap bays
Rack configuration
SCSI ID 0
Note: The SCSI IDs for the hot-swap drives are printed on the bezel, immediately
v Your server comes with one 3.5-inch, 1.44 MB diskette drive.
v Your server also comes with one integrated drive electronics (IDE) CD-ROM
v You can install two additional 5.25-inch, half-high, removable-media drives or one
Non-hot-swap
bay A
Non-hot-swap
bay B
Non-hot-swap
bay C
Hot-swap bays
SCSI ID 4
SCSI ID 1 SCSI ID 3
SCSI ID 2
adjacent to the hot-swap drive bays (see Table 8 on page 112).
drive. The CD-ROM drive bay supports a 5.25-inch, half-high, removable-media
drive.
additional 5.25-inch, full-high, removable-media drive in the removable-media
drive bays (A and B). The server supports full-high and half-high DLT, SDLT, and
USB connector
Non-hot-swap
bay D
SCSI ID 5
Hard disk drive
activity light
Hard disk drive
status light
SCSI ID 4
SCSI ID 3
SCSI ID 2
SCSI ID 1
SCSI ID 0
SCSI ID 5
Hard disk drive
activity light
Hard disk drive
status light
Chapter 4. Customer replaceable units
Non-hot-swap
bay A
Non-hot-swap
bay B
Non-hot-swap
bay C
Non-hot-swap
bay D
USB connector
75