IBM 8185 - ThinkCentre M50 - 256 MB RAM User Manual page 54

4. Remove the metal shield from the drive bay by inserting a flat-blade
5. Pivot the drive-bay latch handle toward the front of the computer and then
6. Make sure the drive that you are installing is set correctly as either a master or
38
User Guide
screwdriver into one of the slots and gently prying it loose.
pivot the drive-bay cage upward, as shown, until it is latched in the upright
position.
a slave device.
Note: A serial ATA hard disk drive does not need to be set as either a master
or a slave device.
v If it is the first CD drive or DVD drive, set it as a master device.
v If it is an additional CD drive or DVD drive, set it as a slave device.
v If it is an additional parallel ATA hard disk drive, set it as a slave device.
Refer to the documentation that comes with your drive for master/slave
jumper information.