Advanced Settings - IBM 8185 - ThinkCentre M50 - 256 MB RAM User Manual

1. Start the IBM Setup Utility program (see "Starting the IBM Setup Utility
2. Select Startup.
3. Select Startup Sequence. See the information displayed on the right side of the
4. Select the sequence of devices for the Primary Startup Sequence, the Automatic
5. Select Exit from the IBM Setup Utility menu and then Save Settings.
If you have changed these settings and want to return to the default settings, select
Load Default Settings on the Exit menu.

Advanced settings

On some computer models, the Advanced settings menu includes a setting to
Enable/Disable HyperThreading. This feature works only with
HyperThreading-aware operating systems such as Microsoft Windows XP. The
default setting for HyperThreading is Enabled. However, if you select Set Defaults
(HyperThreading is Enabled) and are using an operating system other than
Windows XP, your computer performance might be degraded. Therefore, you
should always set HyperThreading to disabled unless you are sure your operating
system supports hyperthreading.
102
User Guide
program" on page 99).
screen.
Startup Sequence, and the Error Startup Sequence.