Installing The Server Cover And Bezel; Connecting External Options; Cabling Requirements - IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual

Installing the server cover and bezel

Connecting external options

Cabling requirements

60
Hardware Maintenance Manual: Netfinity 4500R Type 8656
1
Cover
2
Cover-release latch
3
Flanges
To install the server cover:
1. Place the cover-release latch in the open (up) position and align the flanges on the
left and right sides of the cover with the slots on the server chassis.
2. Close the cover-release latch.
To install the bezel:
1. Align the trim bezel with the front of the server.
2. Press inward on the top sides of the bezel and press the bezel toward the server
until it clicks into place.
To complete the installation:
If you disconnected any cables from the back of the server, reconnect the cables; then,
plug the power cords into properly grounded electrical outlets.
If you install a SCSI adapter, you can attach a SCSI storage expansion enclosure to
your server.
To select and order the correct cables for use with external devices, contact your IBM
reseller or IBM marketing representative.
For information about the maximum length of SCSI cable between the terminated
ends of the cable, see ANSI SCSI Standards:
• X3.131-1986 (SCSI)
• X3.131-1994 (SCSI-2)
• X3T10/1071D
Adhering to these standards ensures that your server operates properly.