Removing The Hot-Swap Hard Disk Drive Backplane - IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual

Removing the hot-swap hard disk drive backplane

106
Hardware Maintenance Manual: Netfinity 4500R Type 8656
To remove the hot-swap hard disk drive backplane:
1. Remove the cover. See "Removing the cover and bezel" on page 47.
2. Disconnect cables.
Remove the screw 1 from the top of the assembly.
3.
Gently slide the SCSI backplane assembly 2 up to remove.
4.
1
Backplane bracket
2
Backplane board
3
Screws (4)
To remove the hot-swap hard disk drive backplane:
1. Remove the cover. See "Removing the cover and bezel" on page 47.
2. Pull out the hard drives in order to disconnect them from the backplane.
Remove the screw from the top of the backplane bracket 1 .
3.
4. Lift the backplane from the chassis.
Remove the cables from the backplane 2 .
5.
Remove the four screws 3 .
6.
Gently lift up to remove the backplane board 2 .
7.