IBM Netfinity 4500R Type 8656 Hardware Maintenance Manual page 29

Table 2. Novell NetWare or IntraNetWare ODI driver messages for the Ethernet controller.
PCNTNW-NW-079 The Multiple Link Interface Driver (MLID) did not initialize MSMTx Free
PCNTNW-NW-086 The driver parameter block is too small.
PCNTNW-NW-087 The media parameter block is too small.
PCNTNW-NW-091 The hardware configuration conflicts.
PCNTNW-NW-126 The group bit in the node address override was cleared.
PCNTNW-NW-127 The local bit in the node address override was set.
PCNTNW-NW-164 The device was not found.
PCNTNW-NW-165 The device was not found at IOADDRESS.
PCNTNW-NW-167 PCI scan specified, device not found.
Count.
Explanation: The MSMTx Free Count is not initialized correctly.
Action: Restart the server. If the problem persists, go to "Starting the
diagnostic programs" on page 14 to run the diagnostic programs. .
Explanation: The driver parameter block is too small.
Action: Restart the server. If the problem persists, go to "Starting the
diagnostic programs" on page 14 to run the diagnostic programs.
Explanation: The driver media parameter block is too small.
Action: Restart the server. If the problem persists, go to "Starting the
diagnostic programs" on page 14 to run the diagnostic programs.
Explanation: You tried to load a new frame type for the existing controller.
The hardware assumptions made in doing so are incorrect. This error can
also occur if you try to specify a mode (such as, redundancy) that conflicts
with another specified mode.
your hardware configuration matches the software settings.
Explanation: The IEEE address has a group bit that indicates that an address
belongs to a group of stations. This bit is used only as a destination address;
it cannot be used as a source address. You tried to enter a source address
with this bit set. The driver cleared the group bit of the source address.
Action: None necessary, message is for information only.
Explanation: The local bit in the IEEE address format indicates that the
addresses are being managed locally. If you use the node address override
capabilities of this driver to enter a new address, the local bit must be set.
You entered an address without the local bit set. The driver has set the local
bit.
information only.
Explanation: The driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. If the Ethernet
controller is enabled, go to "Starting the diagnostic programs" on page 14 to
run the diagnostic programs.
Explanation: The Ethernet controller cannot be found at the I/O address
specified. Action: The Ethernet controller does not require a
parameter for the I/O address. Remove the I/O address parameter.
Explanation: The driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the problem persists,
go to "Starting the diagnostic programs" on page 14 to run the diagnostic
programs.
Action: Make sure that
Action: None necessary, message is for
21
Diagnostics