HP AB500A - Integrated Lights-Out Advanced User Manual page 40

Parameter Default value
iLO 2 ROM-Based Enabled
Setup Utility
Require Login for iLO Disabled
2 RBSU
Show iLO 2 during Disabled
POST
Serial Command Line Enabled-
Interface Status Authentication
Required
Serial Command Line 9600
Interface Speed
Minimum Password 8
Length
Server Name —
Authentication Failure Enabled-Every
Logging 3rd Failure
Descriptions
This setting enables or disables the iLO 2 ROM-Based Setup
Utility. Normally, the iLO2 Option ROM prompts you to press
F8 to enter RBSU, but if iLO 2 is disabled or iLO 2 RBSU is
disabled, the RBSU prompt is bypassed.
This setting enables RBSU access with or without a user-
credentials challenge. If this setting is Enabled, and you press
F8 during POST to enter iLO 2 RBSU, a login dialog box
appears.
This setting enables the display of the iLO 2 network IP
address during the host server POST process.
This setting enables you to change the login model of the CLI
feature through the serial port. The following settings are
valid:
•
Enabled—Authentication Required
•
Enabled—No Authentication
•
Disabled
This setting enables you to use the serial port to change the
speed of the serial port for the CLI feature. The following
speeds (in bits/s) are valid: 9600, 19200, 38400, 57600,
and 115200. The serial port configuration must be set to No
parity, 8 data bits, and 1 stop bit (N/8/1) for proper
operation. The serial port speed that is set by this parameter
must match the speed of the serial port set in the System
ROM RBSU setup.
This setting specifies the minimum number of characters
allowed when a user password is set or changed. The
character length can be set at a value from 0 to 39.
This setting enables you to specify the host server name. This
value is assigned when using HP ProLiant Management
Agents. If you do not use the agents and the host unnamed
message appears, you can change it here. If the agents are
running, the value you assign can be overwritten.
To force the browser to refresh, save this setting, and press
F5.
This setting allows you to configure logging criteria for failed
authentications. All login types are supported and every
login type works independently. The following are valid
settings:
•
Enabled-Every Failure—A failed login log entry is
recorded after every failed login attempt.
•
Enabled-Every 2nd Failure—A failed login log entry is
recorded after every second failed login attempt.
•
Enabled-Every 3rd Failure—A failed login log entry is
recorded after every third failed login attempt.
•
Enabled-Every 5th Failure—A failed login log entry is
recorded after every fifth failed login attempt.
•
Disabled—No failed login log entry is recorded.
Configuring iLO 2 40