Front I/O, Power Switch Assembly
The front I/O and power switch/LEDs are one assembly, attached to the front of the chassis. Push the
assembly into the chassis to remove.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the chassis fan
5.
Rotate the drive cage to its upright position.
6.
Disconnect the four cables from the system board as follows:
●
Yellow connector labeled FRNT USB1
●
Green connector labeled FRNT USB2
●
Blue connector labeled FRNT AUD
●
Black connector labeled PB/LED
7.
Remove the screw that secures the assembly to the front of the chassis.
Figure 6-57
80
Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis
(Preparation for Disassembly on page
(Computer Access Panel on page
(Front Bezel on page
(Front Fan Assembly on page
Removing the front I/O, power switch/LED assembly screw
43).
44).
78).
35).