HP SignagePlayer mp8000r Maintenance And Service Manual page 65
Maintenance & service guide: hp signageplayer mp8000r and mp8000s
Hide thumbs
Also See for SignagePlayer mp8000r:
- Illustrated parts and service map (4 pages) ,
- Getting started manual (36 pages)
Table of Contents
Advertisement
8.
To install a new expansion card, hold the card just above the expansion socket on the system
board then move the card toward the rear of the chassis (1) so that the bracket on the card is
aligned with the open slot on the rear of the chassis. Press the card straight down into the
expansion socket on the system board (2).
Figure 6-21
Installing an Expansion Card
NOTE:
When installing an expansion card, press firmly on the card so that the whole connector
seats properly in the expansion card slot.
9.
Rotate the slot cover retention latch back in place to secure the expansion card.
Figure 6-22
Closing the Expansion Slot Retainer
10.
Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
11.
Replace the access panel.
Expansion Cards
55
Advertisement
Table of Contents
