Table of Contents
Advertisement
Modifying the Startup Configuration
Specifying the Filename to Read and Write the System Configuration
By default, the Cisco IOS software uses the file config.text to read and write a nonvolatile copy of the
system configuration. However, you can specify a different filename, which will be loaded during the
next boot cycle.
Note
On stacking-capable switches, this command only works properly from a standalone switch.
Beginning in privileged EXEC mode, follow these steps to specify a different configuration filename:
Command
Step 1
configure terminal
Step 2
boot config-file flash:/file-url
Step 3
end
Step 4
show boot
Step 5
copy running-config startup-config
To return to the default setting, use the no boot config-file global configuration command.
Booting Manually
By default, the switch automatically boots up; however, you can configure it to manually boot up.
On stacking-capable switches, this command only works properly from a standalone switch.
Note
Beginning in privileged EXEC mode, follow these steps to configure the switch to manually boot up
during the next boot cycle:
Command
Step 1
configure terminal
Step 2
boot manual
Step 3
end
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
3-20
Chapter 3
Assigning the Switch IP Address and Default Gateway
Purpose
Enter global configuration mode.
Specify the configuration file to load during the next boot cycle.
For file-url, specify the path (directory) and the configuration
filename.
Filenames and directory names are case sensitive.
Return to privileged EXEC mode.
Verify your entries.
The boot config-file global configuration command changes the
setting of the CONFIG_FILE environment variable.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable the switch to manually boot up during the next boot cycle.
Return to privileged EXEC mode.
OL-13270-06
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
