Configuring 802.1x Authentication
•
•
•
•
•
•
•
•
•
Default 802.1x Authentication Configuration
Table 9-4
Table 9-4
Feature
Switch 802.1x enable state
Per-port 802.1x enable state
AAA
RADIUS server
•
•
•
Host mode
Control direction
Periodic re-authentication
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
9-34
Configuring 802.1x User Distribution, page 9-56
Configuring NAC Layer 2 802.1x Validation, page 9-58
Configuring an Authenticator and a Supplicant Switch with NEAT, page 9-59
Configuring 802.1x Authentication with Downloadable ACLs and Redirect URLs, page 9-60
(optional)
Configuring VLAN ID-based MAC Authentication, page 9-63
Configuring Flexible Authentication Ordering, page 9-64
Configuring Open1x, page 9-64
Disabling 802.1x Authentication on the Port, page 9-65
Resetting the 802.1x Authentication Configuration to the Default Values, page 9-66
shows the default 802.1x authentication configuration.
Default 802.1x Authentication Configuration
IP address
UDP authentication port
Key
Chapter 9
Configuring IEEE 802.1x Port-Based Authentication
(optional)
(optional)
(optional)
(optional)
(optional)
Default Setting
Disabled.
Disabled (force-authorized).
The port sends and receives normal traffic without
802.1x-based authentication of the client.
Disabled.
None specified.
•
1812.
•
None specified.
•
Single-host mode.
Bidirectional control.
Disabled.
3600 seconds.
2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
(optional)
(optional)
(optional)
OL-13270-06