Chapter 1
Overview
For information about assigning an IP address by using the browser-based Express Setup program, see
Note
the getting started guide. For information about assigning an IP address by using the CLI-based setup
program, see the hardware installation guide.
If you do not configure the switch at all, the switch operates with these default settings:
•
Default switch IP address, subnet mask, and default gateway is 0.0.0.0. For more information, see
Chapter 3, "Assigning the Switch IP Address and Default Gateway," andChapter 22, "Configuring
DHCP Features and IP Source Guard."
Default domain name is not configured. For more information, see
•
IP Address and Default Gateway."
DHCP client is enabled, the DHCP server is enabled (only if the device acting as a DHCP server is
•
configured and is enabled), and the DHCP relay agent is enabled (only if the device is acting as a
DHCP relay agent is configured and is enabled). For more information, see
the Switch IP Address and Default Gateway,"
Source Guard."
•
Switch stack is enabled (not configurable). For more information, see
Stacks."
No passwords are defined. For more information, see
•
System name and prompt is Switch. For more information, see
•
Switch."
NTP is enabled. For more information, see
•
DNS is enabled. For more information, see
•
TACACS+ is disabled. For more information, see
•
Authentication."
RADIUS is disabled. For more information, see
•
Authentication."
The standard HTTP server and Secure Socket Layer (SSL) HTTPS server are both enabled. For more
•
information, see
IEEE 802.1x is disabled. For more information, see
•
Port-Based Authentication."
OL-13270-06
Chapter 6, "Configuring Switch-Based Authentication."
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
Default Settings After Initial Switch Configuration
Chapter 3, "Assigning the Switch
and
Chapter 22, "Configuring DHCP Features and IP
Chapter 7, "Managing Switch
Chapter 5, "Administering the Switch."
Chapter 5, "Administering the
Chapter 5, "Administering the Switch."
Chapter 5, "Administering the Switch."
Chapter 6, "Configuring Switch-Based
Chapter 6, "Configuring Switch-Based
Chapter 9, "Configuring IEEE 802.1x
Chapter 3, "Assigning
1-17