Side Stand Inspection - DAELIM CORDI Owner's Manual

[REAR WHEEL REMOVAL]
① Set vehicle on main stand in upright
position on level ground.
② Loosen the rear brake adjuster nut.
REAR BRAKE ARM
ADJUST NUT
③ Remove the muffler.
④ Loosen the rear wheel axle nut.
⑤ Remove the lock washer and the rear
wheel.
MUFFLER
AXLE NUT
⑥ Install in the reverse order of removal.
REAR AXLE NUT TORQUE
: 11kgf· · m
WARNING
●If a torque wrench was not used for
installation, see your authorized
dealer as soon as possible to verify
proper assembly.
Improper assembly may lead to loss
of braking capacity.

SIDE STAND INSPECTION

●Erect main stand and place vehicle
in up right position on level ground.
●Check the spring for damage or loss
of tension and the side stand assembly
for freedom of movement.
SIDE STAND SWITCH
SIDE STAND SPRING
●For model with a side stand switch,
check the side stand ignition cut off
system;
① Put the side stand up.
② Start the engine.
③ Lower the side stand. The engine
should stop as you put the side
stand down.
●If the side stand system does not
operate as described, inspect it in the
closest authorized repair center.
39