DAELIM CORDI Owner's Manual page 46

HEADLIGHT SOCKET
FRONT COVER
LUMINATION
ANGLE ADJUSTING
BOLT
③ Press a headlight bulb with a light
force and rotate it to counterclockwise
to disassemble it.
④ Replace with new bulb. Apply reverse
order of disassembly for assembly.
HEADLIGHT BULB : 12V 35/35W
[HEADLIGHT LUMINATION ANGLE]
●Adjust headlight lumination angle by
turning an adjusting bolt on a headlight.
(Use type screwdriver.)
●Adjustment is to be carried out with a
front cover not disassembled.
44
●Lumination
incorrectly may dazzle a facing
driver's eyes or result in difficulty to
show the forward.
RUBBER COVER
[TAIL/STOP LIGHT BULB]
① Loosen two screw to disassemble tail
HEADLIGHT BULB
light lens.
② Press a bulb with a light force and
rotate it to counterclockwise to
disassemble it.
③ Replace it with new bulb. Apply
reverse order of disassembly for
assembly.
TAIL/STOP LIGHT BULB : 12V 21/5W
CAUTION
angle adjusted
BULB
TAIL LIGHT LENS
SCREWS
CAUTION
●When disassembling, care is to be
taken for ensuring that a tail light
lens can not be damaged.
●When replacing a tail light lens, be
sure to assemble lens seal securely.
[WINKER BULB]
<Front Winker Bulb>
① Loosen one screw to disassemble a
winker lens.
② Rotate a bulb to counterclockwise to
disassemble.
③ Replace it with new bulb. Apply
reverse order of disassembly for
assembly.
FRONT WINKER BULB : 12V RY 10W
BULB
WINKER LENS
SCREW