Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual page 30

30 Installing Workflow 7.0
Installing Workflow Designer
To install Workflow Designer
1 Run the Workflow Solution Setup file.
The installer is located in the directory to which you downloaded it. By default
the Workflow installer is downloaded to the desktop. If you have not yet
downloaded the Workflow installer, you can download it through the Symantec
Management Console.
See Downloading the Workflow installer through the Symantec Management
Console " on page 22.
2
In the Server Roles step, click the pieces of Workflow 7.0 that you want to
install on the local computer, and then click Next.
See About Workflow 7.0"
If you want to install only Workflow Server, select only that piece. The
installation steps on the left are affected by the options that you choose. The
more options you select on the right, the more steps you will have on the left.
You should always check Workflow Server.
Clicking Show Advanced Settings During Installation lets you edit the default
installation location and ORM settings.
3 On the Server Configuration step, select which Website and base URL you
want to use.
The Website mentioned here is the IIS Website on which your projects will
be published.
Base URL refers to a resolvable URL to access the Workflow Server. If you
are installing on a design-only computer (not a publishing server), the base
URL can be the local computer name or IP address. If you are installing on a
publishing server with an externally accessible URL, use that URL.
4
On the Workflow Designer Tasks step, configure the installation options.
Old Tool Preferences refers to task tray application settings and Workflow
Designer tool settings (configured in File > Edit Tool Preferences in the
Workflow loading window) carried over from your previous installation of
Workflow.
5 On the Notification Server Credentials step, configure the Notification Server
options.
Contact your network administrator if you need help.
on page 9.