About Predefined Inventory Policies - Symantec ALTIRIS INVENTORY SOLUTION 7.0 SP2 - V1.0 Manual
Hide thumbs
Also See for ALTIRIS INVENTORY SOLUTION 7.0 SP2 - V1.0:
Table of Contents
Advertisement
Predefined inventory policies and tasks
Table 4-1
Policy
Enabled by
default?
Collect Full
Yes
Inventory
Collect Delta
No
Hardware
Inventory
Collect Delta
No
Software
Inventory
Gathering inventory on managed computers
Default
Default
schedule
target
Weekly,
All
every
computers
Monday at
with the
18:00 (6:00
Inventory
P.M.)
plug-in
installed
Monthly,
All
every first
computers
Monday at
with the
18:00 (6:00
Inventory
P.M.)
plug-in
installed
Weekly,
All
every
computers
Monday at
with the
18:00 (6:00
Inventory
P.M.)
plug-in
installed
About predefined inventory policies
Notes
This policy collects a full inventory.
By default it collects hardware and
operating system, software, and file
properties inventory data.
You can use this default to gather an
initial inventory, and then again
weekly.
Even though this policy is enabled by
default, you must install the
Inventory plug-in on target
computers before inventory data is
gathered.
See
"Preparing managed computers
for inventory and metering"
on page 25.
By default, this policy collects only
the hardware and operating system
inventory data that has changed since
the last full hardware inventory.
See
"Inventory advanced options:
Run options tab"
on page 51.
By default, this policy collects only
the software inventory data that has
changed since the last full software
inventory.
See
"Inventory advanced options:
Run options tab"
on page 51.
35
Advertisement
Table of Contents
