Installing The Deployment Plug-In - Symantec ALTIRIS DEPLOYMENT SOLUTION 7.1 - V1 Manual

Installing the Deployment plug-in

Add OS Licenses
See "Adding an OS license"
Sysprep Imaging Configuration
See "Configuring deployment and migration settings"
Configure Deployment Settings
See "Adding new system configuration settings"
Preboot Configurations
See "Creating a PXE preboot image"
PXE Server Configuration
See "About configuring a PXE server"
Initial Deployment task setup
The primary Notification Server has all of the necessary components that
are required for full functionality. This task completes all of the steps that
are necessary for a single computer to get set up and working.
See "Configuring the initial deployment settings"
If you need the Automation Directory install, PXE, or have remote site
servers, access these policies directly.
See "About Deployment Solution policies"
Install Deployment Plug-in
See "Installing the Deployment plug-in"
You can expand each link for a description of that task.
3 After you complete each task, click the green circle in front of that task to
add a checkmark.
The Deployment plug-in lets you capture and deploy disk images, migrate the
data settings and the personality settings, and change your system settings. This
environment is used to manage the computers that are outside of the operating
system.
The Deployment plug-in replaces the former Deployment Solution agents, such
as AClient, DAgent, or ADLAgent. If you need them, AClient and DAgent can
coexist with the Deployment plug-in.
You can enable the Symantec firewall on the client computer and enable the
Windows firewall on Notification Server. However, to install the Deployment
plug-in by pushing it to computers, you need to disable one of these firewalls.
Getting started with Deployment Solution
Installing the Deployment plug-in
on page 33.
on page 65.
on page 33.
on page 36.
on page 20.
on page 19.
on page 29.
on page 36.
19