Appendix; Eap Messages; Eap-Fast Error Messages And Prompts - Cisco AIR-CB21AG-W-K9 Installation And Configuration Manual

EAP Messages

This appendix describes EAP-FAST, PEAP-GTC and LEAP error messages and prompts. This appendix
also provides guidelines for creating strong passwords.
The following topics are covered in this appendix:
•
•
•

EAP-FAST Error Messages and Prompts

Error Message Automatic PAC provisioning is enabled for this profile. However, a
valid PAC that matches the server to which the client adapter is connecting could
not be found. Do you wish to obtain a new security credential (PAC)?
Caution To prevent possible attacks from rogue access points, do not reprovision a PAC unless it is necessary.
Error Message While attempting to provision your PAC during auto-provisioning, the
network access device failed to authenticate itself. This condition might indicate
an attack on your password by a rogue access device. Try again with your current
password?
If the authentication attempt fails again, contact your system administrator to report a rogue access
Note
device. Use strong passwords in the future to reduce the chance of your password being compromised;
see the
Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide for Windows Vista
OL-16534-01
EAP-FAST Error Messages and Prompts, page A-1
PEAP-GTC and LEAP Error Messages and Prompts, page A-6
Creating Strong Passwords, page A-9
Click Yes to provision a new PAC for this server using your existing credentials
Recommended Action
or click No to cancel the operation. If you click No, the client adapter will fail the authentication.
Click Yes to attempt to reauthenticate with your current password. Click No to
Recommended Action
cancel the operation.
"Creating Strong Passwords" section on page A-9
A P P E N D I X
for tips on creating strong passwords.
A
A-1