Advertisement

Quick Links

Contents
This document contains the following sections:
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2005 Cisco Systems, Inc. All rights reserved.
Introduction, page 2
Caveats, page 24

Advertisement

Table of Contents
loading

Summary of Contents for Cisco CB21AG

  • Page 1: Table Of Contents

    Cisco Product Security Overview, page 29 Obtaining Technical Assistance, page 30 • • Obtaining Additional Publications and Information, page 32 Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA Copyright © 2005 Cisco Systems, Inc. All rights reserved.
  • Page 2: Release Notes For Cisco Aironet 802.11A/B/G Client Adapters (Cb21Ag And Pi21Ag) Install Wizard 2.5

    Introduction This document describes system requirements, important notes, new and changed information, installation and upgrade procedures, and caveats for CB21AG and PI21AG client adapter Install Wizard release 2.5 and the following software included in the Install Wizard file: CB21AG and PI21AG client adapter driver release 2.5 •...
  • Page 3: Important Notes

    Caution client adapter software. The Aironet Desktop Utility (ADU) must be used with CB21AG and PI21AG cards, and the Aironet Client Utility (ACU) must be used with all other Cisco Aironet client adapters. Installing the Novell Client If you are going to use the Novell Client, be sure to install it on your computer prior to installing the client adapter software.
  • Page 4: Uninstalling Software Components

    EAP-FAST Fails When Access Point Configured as Local RADIUS Server The client adapter fails to authenticate using EAP-FAST when the access point is running Cisco IOS Release 12.3(2)JA2 and is configured as a local RADIUS server. The following message appears: “Unable to EAP-FAST authenticate the wireless user in the specified amount of time.
  • Page 5: New And Changed Information

    Configuration Guide (OL-4211-04) pertains specifically to CB21AG and PI21AG client adapters. If you are using a Cisco Aironet 340, 350, or CB20A client adapter, refer to the Installation and Configuration Guide for that client adapter and your computer’s operating system.
  • Page 6 Configure the site survey utility to automatically copy the contents of the AP scan list to a log file – Enable AP scan logging – View or delete the AP scan log Save or open the AP scan list – Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 7 Cisco Aironet 350 series and CB20A wireless LAN client adapter profiles to profiles that can be used with Cisco Aironet CB21AG and PI21AG client adapters. The tool is meant to migrate profiles with minimal modification, but its behavior can be altered by command line options. The legacy 350 and CB20A profiles are not deleted or modified in any way.
  • Page 8: Installing Or Upgrading Client Adapter Software

    Installing or Upgrading Client Adapter Software This section describes how to initially install or upgrade to CB21AG and PI21AG Install Wizard 2.5 on a computer running Windows 2000 or XP. If the client adapter software is not installed on your computer, follow the instructions in the “Installing the Client Adapter Software”...
  • Page 9 Double-click the file. The “Starting InstallShield Wizard” message appears followed by the Preparing Step 11 Setup window (see Figure 1) and the Cisco Aironet Installation Program window (see Figure Figure 1 Preparing Setup Window Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 10 Installing or Upgrading Client Adapter Software Figure 2 Cisco Aironet Installation Program Window Click Next. The Setup Type window appears (see Figure Step 12 Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 11 You must manually install the driver later using the Update Device Driver Wizard. See Chapter 9 of the Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide (OL-4211-04) for instructions. Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 12 Figure 4), check the Install Step 14 Cisco Aironet Site Survey Utility check box if you want to install a utility that helps you to determine the best placement of infrastructure devices within your wireless network. Click Next. Figure 4...
  • Page 13 If you want to copy the driver to a different drive or directory, click Browse, choose a new Note location, click OK, and click Next. Step 17 The Select Program Folder window appears (see Figure Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 14 If your computer is running Windows 2000, go to Step 25. If your computer is running Windows XP, the IMPORTANT: Please Read! window appears (see Figure Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 15 Installing or Upgrading Client Adapter Software Figure 7 IMPORTANT: Please Read! Window Read the information displayed and click Next. The Choose Configuration Tool window appears (see Step 20 Figure Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 16 If you chose Cisco Aironet Desktop Utility (ADU) in Step 21, go to Step 25. If you chose Third-Party Step 23 Tool, the Enable Tray Icon window appears (see Figure Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 17 Figure 9 Enable Tray Icon Window Check the Enable Cisco Aironet System Tray Utility (ASTU) check box if you want to be able to use Step 24 ASTU even though you have chosen to configure your client adapter through a third-party tool instead of ADU and click Next.
  • Page 18 Choose Use the following IP address and enter the IP address, subnet mask, and default gateway address of your computer (which can be obtained from your system administrator). Click OK to close each open window. Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 19: Upgrading The Client Adapter Software

    Step 29 Upgrading the Client Adapter Software Follow these steps to upgrade your CB21AG or PI21AG client adapter software to release 2.5 using the settings that were selected during the last installation. If you want to upgrade your client adapter software using new installation settings, you must uninstall...
  • Page 20 Double-click the file. The “Starting InstallShield Wizard” message appears followed by the Preparing Step 11 Setup window (see Figure 11) and the Previous Installation Detected window (see Figure 12). Figure 11 Preparing Setup Window Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 21 If you click No, you are asked to confirm your decision. If you proceed, the installation process Note terminates. The Setup Status window appears (see Figure 13). Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 22: Installing A Microsoft Hot Fix For Group Policy Delay

    Follow the steps below to obtain and install the hot fix. Note You must be a registered Cisco customer and log into Cisco.com in order to download the hot fix. If you are unable to access the hot fix from Cisco.com, contact Microsoft Support to obtain it. The Windows 2000 support page provides the contact information: http://support.microsoft.com/oas/default.aspx?&c1=508&gprid=7274&...
  • Page 23: Finding Version Numbers

    About Aironet Desktop Utility option from the Help drop-down menu. The About window shows the current version of the following software components: ADU, ACAU, the authentication supplicant, the protocol driver, and the Windows NDIS miniport driver. Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...
  • Page 24: Caveats

    This section describes the open, resolved, and closed caveats for the software components in this release. Open Caveats The following caveats are not resolved in CB21AG and PI21AG client adapter software release 2.5. CSCeh59294—Failure to find domain controller during LEAP authentication •...
  • Page 25 WDS. To work around this problem, manually reauthenticate the client adapter using ADU. Resolved Caveats The following caveats are resolved in CB21AG and PI21AG client adapter software release 2.5. • CSCed93298—The client adapter’s IP address may display incorrectly The client adapter’s IP address may appear as 0.0.0.0 when the adapter is associated to a workgroup...
  • Page 26 Closed Caveats The following caveats, which are listed as open caveats in the Release Notes for Install Wizard 2.1, have been closed and are not resolved in CB21AG and PI21AG client adapter software release 2.5. • CSCed40520—Up to 5-minute delay for initial boot Some computers may experience up to a 5-minute delay during the first boot after installation.
  • Page 27: Troubleshooting

    Getting Bug Information on Cisco.com If you are a Cisco registered user, you can use the Cisco TAC Software Bug Toolkit, which consists of three tools (Bug Navigator, Bug Watcher, and Search by Bug ID Number) that help you to identify existing bugs (or caveats) in Cisco software products.
  • Page 28: Obtaining Documentation

    Cisco products and to view technical documentation in HTML. With the DVD, you have access to the same documentation that is found on the Cisco website without being connected to the Internet. Certain products also have .pdf versions of the documentation available.
  • Page 29: Documentation Feedback

    Register to receive security information from Cisco. • A current list of security advisories and notices for Cisco products is available at this URL: http://www.cisco.com/go/psirt If you prefer to see advisories and notices as they are updated in real time, you can access a Product Security Incident Response Team Really Simple Syndication (PSIRT RSS) feed from this URL: http://www.cisco.com/en/US/products/products_psirt_rss_feed.html...
  • Page 30: Obtaining Technical Assistance

    Use the Cisco Product Identification (CPI) tool to locate your product serial number before submitting Note a web or phone request for service. You can access the CPI tool from the Cisco Technical Support & Documentation website by clicking the Tools & Resources link under Documentation & Tools. Choose Cisco Product Identification Tool from the Alphabetical Index drop-down list, or click the Cisco Product Identification Tool link under Alerts &...
  • Page 31 Cisco engineer. The TAC Service Request Tool is located at this URL: http://www.cisco.com/techsupport/servicerequest For S1 or S2 service requests or if you do not have Internet access, contact the Cisco TAC by telephone. (S1 or S2 service requests are those in which your production network is down or severely degraded.) Cisco engineers are assigned immediately to S1 and S2 service requests to help keep your business operations running smoothly.
  • Page 32: Obtaining Additional Publications And Information

    Visit Cisco Marketplace, the company store, at this URL: http://www.cisco.com/go/marketplace/ Cisco Press publishes a wide range of general networking, training and certification titles. Both new • and experienced users will benefit from these publications. For current Cisco Press titles and other information, go to Cisco Press at this URL: http://www.ciscopress.com...
  • Page 33 CCSP, CCVP, the Cisco Square Bridge logo, Follow Me Browsing, and StackWise are trademarks of Cisco Systems, Inc.; Changing the Way We Work, Live, Play, and Learn, and iQuick Study are service marks of Cisco Systems, Inc.; and Access Registrar, Aironet, ASIST, BPX, Catalyst,...
  • Page 34 Obtaining Additional Publications and Information Release Notes for Cisco Aironet 802.11a/b/g Client Adapters (CB21AG and PI21AG) Install Wizard 2.5 OL-8008-01...

This manual is also suitable for:

Pi21ag

Table of Contents