Table of Contents
Advertisement
Notification of Compliance
C.
NETGEAR Adapters
Regulatory Compliance Information
This section includes user requirements for operating this product in accordance with National laws for usage of radio
spectrum and operation of radio devices. Failure of the end-user to comply with the applicable requirements may
result in unlawful operation and adverse action against the end-user by the applicable National regulatory authority.
Note: This product's firmware limits operation to only the channels allowed in a particular Region or Country.
Therefore, all options described in this user's guide may not be available in your version of the product.
FCC Requirements for Operation in the United States
FCC Information to User
This product does not contain any user serviceable components and is to be used with approved antennas only.
Any product changes or modifications will invalidate all applicable regulatory certifications and approvals
FCC RF Radiation Exposure and SAR Statements
SAR Statement
The Push2TV HD Adapter (PTV2000) for Intel Wireless Display has been tested for body-worn Specific Absorption
Rate (SAR) compliance. The FCC has established detailed SAR requirements and has established that these
requirements have been met while the Push2TV HD Adapter (PTV2000) for Intel Wireless Display was installed in
a host notebook computer.
RF Exposure Information
The radio module has been evaluated under FCC Bulletin OET 65C (01-01) and found to be compliant to the
requirements as set forth in CFR 47 Sections, 2.1093, and 15.247 (b) (4) addressing RF Exposure from radio
frequency devices. This model meets the applicable government requirements for exposure to radio frequency
waves. The highest
SAR level measured for this device was <insert value; get from engineer> W/kg.
FCC Declaration of Conformity
We, NETGEAR, Inc., 350 East Plumeria Drive, San Jose, CA 95134, declare under our sole responsibility that the
Push2TV HD Adapter (PTV2000) for Intel Wireless Display complies with Part 15 Subpart B of FCC CFR47 Rules.
Operation is subject to the following two conditions:
This device may not cause harmful interference, and
•
This device must accept any interference received, including interference that may cause undesired operation.
•
FCC Radio Frequency Interference Warnings & Instructions
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
Appendix C. Notification of Compliance
C
| 27
Advertisement
Table of Contents
