Table of Contents
Advertisement
There are two instances where the auto-connect is attempted.
The auto-connect adapter is discovered when the Intel Wireless Display application is
1.
launched.
If the auto-connect adapter is in the list of adapters when the Intel Wireless Display
2.
application is relaunched. In this case, if a connection is made, it is typically faster than in
case 1, because the application is already running and a new scan is not performed.
There are two ways to select the auto-connect adapter.
On the Adapter properties screen, select the Automatically connect to this adapter
1.
check box. Note that if you have more than one adapter, any other adapter that was
previously selected for auto-connect will no longer have its auto-connect property set.
In the Detected adapters list on the Intel Wireless Display home screen, right-click an
2.
adapter that has previously been connected. This shows an Auto-connect property in a
pop-up menu. A check indicates if this adapter is currently set as the auto-connect adapter
or not. Selecting that menu item changes the autoconnect state of the adapter.
HDTV 1080p Resolution
To experience Intel Wireless Display in full HD 1080p resolution on your TV, you need to have
an 1080P HDTV and one of the following:
An HRV laptop with an 1920 x1080 panel in clone mode.
•
An HRV Huron River platform laptop in extend or remote only mode.
•
To set up extend mode for an HRV Huran River platform laptop:
Before you connect to PTV2000, the laptop screen resolution is 1280 x 800 or
1.
1366 x 768, depending on the laptop.
14 |
Chapter 2. Wireless Display Settings
Push2TV HD TV Adapter for Intel® Wireless Display User Manual
Advertisement
Table of Contents
