Your Video Mode Has Changed; Returning The Adapter To Its Original Firmware And Factory Settings - NETGEAR PTV2000 - Push2TV™ HD-TV ADAPTER User Manual

Your Video Mode Has Changed

The video display resolution might change while you are using Intel Wireless Display. This
can happen regardless of whether you change the display resolution manually or it is
changed by another application. On the Your Video Mode has Changed screen, click the
Restore settings and resume connection button to allow the application to automatically
reset the display to the correct settings. Selecting Keep settings and close connection
results in the display session ending. Intel Wireless Display supports at least one or more of
the following resolutions: 1280 x720, 1280 x768, 1280 x 800, 1366 x 768, 1440 x 900, 1600 x
900, and 1920 x 1080. For information about viewing in HDTV 1080p resolution, see
1080p Resolution
Returning the Adapter to Its Original Firmware and
Factory Settings
This procedure erases the security code for your adapter. After you do this, you will have to
set the adapter up again to work with your TV and your laptop as described in the installation
guide. This procedure also removes any firmware updates that you have installed.
To return the adapter to its original firmware level and its default settings:
Turn off the adapter by pushing the On/Off button on the rear panel.
1.
Press and hold the Restore Factory Settings button.
2.
While you continue to hold the Restore Factory Settings button, press the On/Off button to
3.
turn the adapter back on.
Wait until the LED on the front flashes, then release the Restore Factory Settings button.
4.
The adapter returns to its original firmware level and its default settings.
18 | Chapter 3. Troubleshooting
Push2TV HD TV Adapter for Intel® Wireless Display User Manual
on page 14.
HDTV