[Image/Position] Tab - Panasonic WJ-GXE500 Operating Instructions Manual

*12 • W hen "Frame rate" is set for "Transmission priority", number of users who can access the unit may be
decreased.
*13 • W hen "Frame rate" is selected for "Transmission priority", this setting is available.
*14 • " Frame rate" is synchronized with "Max bit rate (per client) *". For this reason, the frame rate may be lower
than the specified value when any value marked with an asterisk (*) is selected.
*15 • " Unlimited *" is available when "Frame rate" is selected for "Transmission priority".
*16 • T he bit rate is synchronized with "Bandwidth control(bit rate)" on the [Network] tab of "Network" page. For
this reason, the bit rate may be lower than the value when any value with an asterisk (*) on the right is
selected.
*17 • W hen "Unlimited *" is selected for either "MPEG-4(1)" or "MPEG-4(2)", the maximum concurrent access
number is 1 user.
*18 • W hen "Constant bit rate" is selected for "Transmission priority", this setting is available.
*19 • D epending on the setting or photographic subject, images may not be refreshed at the exact designated
interval.
*20 • W hen "Multicast" is selected, set the value of "Bandwidth control(bit rate)" on the [Network] tab of
"Network" page greater than the total value of "Max bit rate (per client) *" of all the channels in use.
*21 • T he following port numbers are unavailable since they are already in use.
10 669, 10 670
*22 • W hen audio is transmitted from the unit, the port number to be used will be the multicast port number
plus "1 000".
*25 • W hen "On" is selected for "MPEG-4 transmission" of "MPEG-4(1)", the setting values selected for
"MPEG-4(1)" will be applied.

[Image/Position] tab

Refer to page 28 for general information about this tab.
Setup items
Ch No.
Menu
Operation buttons
Zoom
Focus
Control pad
40
Setting values (Underlined: default):
1/2/3/4
On/Off
Set
Up
Down
Left
Right
Esc
Reset/Special
All Reset
Zoom out/x1/Zoom in
Auto/Near/Far