Parking Brake; Mower Deck Cut Height Lift Lever - Dixon 2700 Operator's Manual

PARKING BRAKE:

A parking brake is located to the left of the seat.
The engine will kill if control levers are not in the outboard position when
the parking brake is engaged.
To engage brake: pull up and back
To disengage brake: push forward and down
Note:
service brake.
Note:
Release the parking brake before moving mower.
Note:

MOWER DECK CUT HEIGHT LIFT LEVER:

Located to the right and front of the operator.
Controls the cutting height.
Ten positions of adjustment.
Depress trigger and move lever forward to lower deck.
Depress trigger and pull lever back to raise deck.
Select cut height & insert pin into first hole below the lift lever. Ten holes
are provided for a down stop so you can easily return from transport to
desired cut height.
S E A T :
Fore & Aft: Move lever, slide seat fore & aft to desired position, release.
16
CONTROLS
The parking brake is not intended to be used as a
Always set parking brake before dismounting.
Engage parking brake before starting engine.