IBM 88701RX User Manual page 73

7. Press Esc to return to the Configuration Settings window. If you need to
configure the management port, go to "Configuring the management port for
text-based remote access" on page 58.
8. Press Esc to return to the Utility program main window.
9. Use the arrow keys to select Exit Utility from the menu or press Esc to close
the Utility program.
10. Remove the diskette from the diskette drive. The server restarts automatically.
11. Continue with "Installing Advanced System Management device drivers."
Installing Advanced System Management device drivers: You must install the ASM
device drivers for the server. The device drivers enable communication between the
Remote Supervisor Adapter and the server in which it is installed. You can obtain
the most current device drivers from http://www.ibm.com/pc/support.
The following sections describe the procedure for installing the ASM device drivers
for the server, depending on your operating system.
Notes:
1. If you are installing device drivers manually, note the following requirements:
v Make sure that the operating system is installed on the server before you
install the ASM device drivers. For information about installing the operating
system, see the documentation that comes with the operating system.
v Before installing the ASM device drivers for the Remote Supervisor Adapter,
stop any system-management application.
2. If you are using ServerGuide to install device drivers and your operating system
is Windows 2000 or Windows Server 2003, ServerGuide installs the ASM device
drivers automatically.
v For Windows 2000 or Windows Server 2003 installations, continue with
"Installing Windows 2000 or Windows Server 2003 ASM device drivers"
v For Windows NT installations, go to "Installing Windows NT ASM device
drivers" on page 62.
After you install the ASM device drivers, go to "Configuring the remote control
password" on page 63 to set the remote control password.
Installing Windows 2000 or Windows Server 2003 ASM device drivers: To install
the ASM device drivers for Windows 2000 or Windows Server 2003, complete the
following steps.
Notes:
1. Do not use the Hardware Wizard to install the drivers. If the Hardware Wizard
starts itself for the installation of any System Management Driver hardware, exit
the Hardware Wizard by selecting Cancel.
®
2. If IBM Netfinity Director, IBM Director, or UM Services is running on the server,
stop the system-management application before proceeding.
Complete the following steps to manually install the Windows 2000 or WIndows
Server 2003 ASM device drivers.
1. Open a command prompt.
2. If you are installing from a diskette, type: a:\WIN2000\SETUP, where a is the drive
letter of the diskette drive.
Chapter 2. Configuring the server
61