IBM 88701RX User Manual page 68

User manual
Table of Contents

Advertisement

Note: For detailed information about using the ASM Web interface and the
text-based user interface, see the Remote Supervisor Adapter User's Guide on the
IBM xSeries Documentation CD.
Table 3. Configuration tasks to enable remote access to the Remote Supervisor Adapter
User interface to Remote
Supervisor Adapter
ASM Web interface using
HTTP
Text-based user interface
using the Telnet protocol
Text-based user interface
using a modem or a null
modem
ASM Web interface using
point-to-point protocol
(PPP)
Text-based user interface
using the Telnet protocol
over PPP
Configuring the Ethernet settings for Web-based remote access: If you have an
accessible, active, and configured dynamic host configuration protocol (DHCP)
server on the network, the hostname, IP address, gateway address, subnet mask,
and DNS server IP address are set automatically. You do not need to perform
further configuration tasks to enable the Ethernet connection because the default
value for the DHCP Setting field is Enabled. If you need to configure the
management port, go to "Configuring the management port for text-based remote
access" on page 58; otherwise, go to "Installing Advanced System Management
device drivers" on page 61.
If you do not have a DHCP server on the network, complete the following steps to
configure the Ethernet settings.
56
xSeries 445 Type 8870: User's Guide
1. With the server turned off, insert the diskette with the downloaded utility
program into the diskette drive; then, turn on the server. The utility starts
automatically, displaying the Remote Supervisor Utility window.
2. Use the arrow keys to select Configuration Settings; then, press Enter. The
Configuration Settings window opens.
Connection to Remote
Supervisor Adapter
LAN using the Ethernet port
Management (COM) port
For the configuration
procedure, see:
"Configuring the Ethernet
settings for Web-based remote
access"
"Configuring the management
port for text-based remote
access" on page 58 and "Setting
up point-to-point protocol" on
page 59

Advertisement

Table of Contents
loading

This manual is also suitable for:

88704rx - eserver xseries 4458870 eserver xseries 445

Table of Contents