Remote Console Redirection - IBM 88701RX User Manual

9. Save and Exit the Configuration/Setup Utility Program.
Deleting a scalable partition
Complete the following steps to delete the scalable partition:
1. Start the Configuration/Setup Utility on the primary server.
2. From the main menu, select Advanced Setup.
3. Select Scalable Partition Settings.
4. Select either Delete ALL Scalable Partition or Delete ONLY Local Scalable
5. Exit the Configuration/Setup Utility program.
6. Turn off the servers.
7. If necessary, remove the SMP Expansion cables and reconnect them according
8. Restart the servers.

Remote console redirection

From the Devices and I/O Ports choice, you can enable and configure the remote
console redirection through the Remote Console Redirection submenu. The
Devices and I/O Ports choice is on the full Configuration/Setup menu only.
Complete the following steps to enable and configure the remote console
redirection feature:
1. Ensure that you have installed and enabled the serial port that comes with your
2. From the Devices and I/O Ports choice, use the arrow keys to select Remote
3. In the Remote Console Redirection window, Enable the remote console
4. Once you have made the necessary changes, press Esc.
5. Select Save Settings; then, press Enter.
6. Confirm your selection; then, exit the Configuration/Setup Utility program.
7. Connect the server to a remote console using a null modem cable.
24
xSeries 445 Type 8870: User's Guide
Note: See the software documentation that comes with your operating system
to install your operating system.
Partition.
Note: Do not select Write Scalable Partition Settings when you delete the
scalable partition.
to your new configuration. See "Connecting the cables" in the Option Installation
Guide on the IBM xSeries Documentation CD.
server. See "Installing the serial port" in the Installation Guide.
Console Redirection; then, press Enter. The Remote Console Redirection
window opens.
redirection and enter the necessary settings for the server to work with a remote
console.
Note: The remote console settings must match those in the Remote Console
Redirection window to ensure proper operation.