Removing and replacing the PCI riser card
Complete the following steps to remove the PCI riser card.
Note:
1. Turn off the server and peripheral devices.
2. Disconnect the power cord; then, disconnect all external cables from the server.
3. Remove the server cover.
4. Loosen the captive screw located adjacent to PCI-X slot 1on the rear of the
5. Remove the expansion-slot cover.
6. Turn the expansion-slot cover until the PCI riser card is facing you.
7. Remove the two screws from the PCI riser card.
8. Gently pull the PCI riser card away from the expansion-slot cover.
To install a PCI riser card, reverse the previous steps.
v Read "Handling static-sensitive devices" on page 29.
v Read "Safety information" on page 87.
server.
Riser card
Chapter 5. Removing and installing FRUs (service only)
59