Table of Contents
Advertisement
Server power features
This section contains information about how to turn your server on and off.
Turning on the server
Statement 13:
DANGER
After you connect the server to an ac power source, the server can be turned on in
any of the following ways:
v You can press the power-control button on the front.
v If the server is turned on and a power failure occurs, the server will start
Complete the following steps to manually turn on the server:
1. Review the information in "Important safety information" on page iii.
2. Turn on all external devices, such as the monitor.
3. Plug the server power cord into the power source.
4. Press the power-control button on the front of the server.
Turning off the server
Complete the following steps to manually turn off the server:
1. Review the information in "Important safety information" on page iii
2. See your operating system documentation for the proper procedure to shut
3. Press the power-control button on the front of the server.
6
xSeries 305 Type 8673: Hardware Maintenance Manual and Troubleshooting Guide
Overloading a branch circuit is potentially a fire hazard and a shock hazard
under certain conditions. To avoid these hazards, ensure that your system
electrical requirements do not exceed branch circuit protection
requirements. Refer to the information that is provided with your device for
electrical specifications.
automatically when power is restored. (You can set the default in the
Configuration/Setup Utility program. Go to Power Management →Automatic
Power on →Previous State.)
Note: While the server is turning on, the power-on LED on the front of the
server is lit.
down the operating system.
When you turn off the server, observe the following precaution.
Statement 5:
Advertisement
Table of Contents
