Dish Network SoloDVR ViP 612 User Manual page 70

Installing a UHF Attenuator
Unwanted UHF signals may interfere with signals from the remote control to the receiver.
To prevent such interference, you can install an F-connector attenuator between 6dB and
15dB. Attenuators are available from many consumer electronics parts stores. Adding this
attenuator will help reduce interference from other devices, but it also cuts down how far
away you can use the remote control.
1
Remove the remote control antenna
from the R A
EMOTE
the receiver back panel.
2
Attach an attenuator (between 6dB
and 15dB) to the R
input.
3
Attach the remote control antenna to
the attenuator.
input on
NTENNA
A
EMOTE NTENNA
Remote Control Setup
Improving Receiver Control
65