Setting Up Using Device Codes Scan - Dish Network Solo 381 User Manual

Instructions
7
Press POUND (#).
8
Press POWER to turn off the device. If
the device does not turn off, go to
step 10.
9
Turn the device back on and try some
other buttons to make sure they work.
If the code works for other buttons,
stop here.
10
If the code doesn't work, redo steps 3
through 9 with another device code
from the tables.
11
If you can't find a code that works try,

Setting Up Using Device Codes Scan

that follows.
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 93, use this procedure to scan
the remote control's memory for the device code. In the instructions below, the column on the left
contains the instructions and the column on the right provides additional information.
Instructions
1
Turn the device on.
2
Press and hold the mode button until
all the other mode buttons light up, and
then let go of the button. The mode
button flashes.
Remote Control Setup
Controlling Other Components
Additional Information
If you entered the code correctly, the mode
button flashes three times.
If the code works, the device should turn off.
Sometimes POWER works when other buttons
don't.
Try every code listed for your brand until one
works for your device.
Additional Information
Use the device's front panel buttons or its
remote control.
For example, hold TV for a TV until all of the
other mode buttons light. When you let go, TV
will flash.
51