Additional Information; Setting Up Using Device Codes Scan - Dish Network Duo ViP 222 User Manual

Chapter 9
Controlling Other Components

Setting Up Using Device Codes Scan

If the code for your device is not listed in the tables starting on
find a code that worked for your device, use this procedure to scan the remote control's
entire memory for the device code. In the instructions below, the column on the left
contains the instructions and the column on the right provides additional information.
1
Turn the device on.
2
Press and hold the mode button until all the
mode buttons light up, and then release the
device mode button. The button flashes.
3
AUX
For
VCR, or 2 for a tuner or amplifier. Then
press the
4
Press the remote's
5
Press the
repeatedly until your device turns off. You
can press the
and repeat the last code tested. When a
code turns of your device, go to Step 6.
6
Press the remote's
7
Turn the device back on and try some other
buttons to make sure that they work also.
8
If necessary, then repeat this procedure
until you've tried all available codes. Stop
when you have found the best code for
your device.
64
Instructions
mode only. Press 0 for TV, 1 for
STAR
(*) button.
POWER
button.
UP ARROW
slowly and
DOWN ARROW
to go back
POUND (#)
button.
page 119

Additional Information

Use the device's front-panel buttons or its original
remote control.
For example, for a TV, hold the
all of the other device mode buttons light. When you
let go of it, the TV mode button will start flashing.
This step is for specifying the type of device that will
AUX
be programmed in mode. If you're not
AUX
programming a device in
This puts your remote control in code scan mode.
UP DOWN ARROW
As you press the or
remote tries each code in the memory to see if it can
turn off your device. When your device turns off, you
have found a code that might work.
Note: The mode button for the device will flash
rapidly eight times when you have scanned all the
available codes in memory for that device type.
The device mode button flashes three times if you
have entered the code correctly, and stores the code
that you found.
POWER
Sometimes works for a device when other
buttons do not. If using Limited Mode, then also try
VOLUME
the remote's or
You may need to repeat the device-code scan to find
the best code for your device.
Note: This process could take a long time, because
of this remote's very large device-code database.
or if you could not
TV
mode button until
mode, skip to step 4.
, the
MUTE
button(s).