Axis 27981R1 User Manual page 77

Upgrading using FTP
Caution!
AXIS 5400+ / AXIS 5600+ User's Manual
7. If you do not have a default password, just click Next >. If some of your
servers use a different User ID or Password than the default entries, they will
be displayed in the Remaining servers list. Enter the User ID and Password
for each individual server. Click Next >.
8. Name the upgrade job. This is optional, so you can leave the field blank if
you want. Click the Start button to start the upgrading job.
9. You can view the progress of the job in the Event Log.
Refer to "Using AXIS ThinWizard for Print Server Management" on page
84, for more information about AXIS ThinWizard.
To upgrade over the network using FTP you will need a file with the new
print server firmware. The name of this file is in the form
.
product_version.bin
Ensure that FTP Enabled is set to yes. To check this parameter, browse to
the print server and select Admin | Network Settings | Detailed View |
TCP/IP Network.
Be careful not to interrupt the file transfer. If the transfer is interrupted, the print server may
have to be re-initialized by your dealer.
The objective of this example is to upgrade a print server to firmware
version 7.10.
The description below from a typical Windows session uses the following
examples:
• Print server model: AXIS 5400+
• IP address of print server: 192.168.3.191
• New firmware version name: 5400p_v2_7_10.bin
Updating the Firmware
77