Disarming Without A Transmitter; Remote Siren Silencing - Clifford AVANTGUARD 5 Manual

Hide thumbs Also See for AVANTGUARD 5:

Table of Contents

Alert. If the siren is active when the system is disarmed you will hear

two chirps but the system is not disarmed. (Refer to the Remote Siren

Silencing section of this guide.) However, if the alarm completes the full

trigger cycle when disarmed you will hear three chirps.

disarming without a transmitter

This feature allows you to disarm the system without the transmitter

should it be lost, damaged, or disabled. In order to disarm without a

transmitter, you must have the vehicle's ignition key, know where the

PlainView 2 Valet switch is located, and have the PIN code. Be sure to

check with the installer for the location of the PlainView 2 Valet switch.

Please refer to the Disarm/Valet Mode section of this guide for instruc-

tions to enter the pin code.

This system offers remote siren silencing. Remote siren silencing is a fea-

ture that makes it possible to silence and reset the system when it is

triggering without disarming the system. If the system is triggered and

the siren has been sounding, press

on the transmitter to stop the

trigger and return the unit to the armed state. This prevents you from

disabling the system should you wish to silence it without visually

checking the vehicle. After resetting the system, press

again to

disarm the system.

Table of Contents