Disarming Without A Transmitter; Silent Mode - Clifford Ultramax XL-4500 Owner's Manual

Table of Contents

Disarming Without a Transmitter

If your remote transmitter is lost or damaged, you can manually

disarm your vehicle security system. To disarm the system without

a transmitter, you must have the vehicle's ignition key and know

where the Valet

switch is located. Be sure to check with your

installer at the time of installation for both the location and the

preset response (1-5 presses) of the Valet

To disarm the security system,

turn the ignition key on and

press the Valet

preset number of times within

15 seconds. If the system does

not disarm, you may have

waited too long; turn the igni-

tion off and repeat the process.

IMPORTANT! The Valet

presses for the disarm function. You must check with the installer to ver-

ify the programming for your individual unit.

LOCATION OF VALET

Use the Silent Mode to temporarily turn off the arm or disarm con-

firmation chirps by briefly pressing

arming the security system. The confirmation chirp(s) will then be

eliminated for that one operation only. To permanently turn off the

arm and disarm confirmation chirps, contact your installation dealer.

2000 Directed Electronics, Inc.

switch the

switch can be programmed to respond to 1-5

SWITCH_____________________________

before either arming or dis-

switch.

DRW-35

Table of Contents