Advertisement
Available languages
Available languages
Temperature Controls
Touch Temperature Controls
The controls are located at the top front of the
refrigerator
corn partment.
Control
Initial
Control
Settings
After plugging the refrigerator
in, set the controls.
• Pressing the _or
D
pads adjusts the controls to
the desired setting.
• The temperature
control range for both
compartments
is 1 through
7 (coldest).
• Initially set the refrigerator
control on 4.
• Initially set the freezer control on 4.
• Let the refrigerator
run at least 8 to 12 hours before
adding food.
Warm
Cabinet
Surfaces
At times, the front of the refrigerator
cabinet may be
warm to the touch. This is a normal occurrence
that
helps prevent moisture from condensing
on the
cabinet. This condition will be more noticeable when
you first start the refrigerator,
during hot weather and
after excessive or lengthy door openings.
Adjusting
the Controls
24 hours after adding food, you may decide that one
or both compartments
should be colder or warmer. If
so, adjust the control(s)
as indicated
in the
Temperature Control Guide table below. See page 19
for instructions
on checking
compartment
temperature.
Except when starting the refrigerator,
do not change
either control more than one number at a time.
* Allow 24 hours for temperatures
to stabilize.
Changing
either control will have some effect on the
temperature
of the other compartment.
Temperature
Control Guide
Refrigerator
too warm
Refrigerator
too cold
Freezer
too
warm
Freezer too cold
Turn refrigerator
OFF
Set the refrigerator
control
to next higher number by
pressing the D
pad.
Set the refrigerator
control
to next lower number by
pressing the G
pad.
Set the freezer control to
next higher number by
pressing the _
pad.
Set the freezer control to
next lower number by
pressing theG
pad.
Press the refrigerator
or
freezer _
pad until a dash
(-) appears in the display.
Energy Saver Switch
[select models)
Off - The refrigerator
uses more energy when this
switch is off, because a heater located in the hinged
seal section of the door is running. This heater helps
prevent condensation
formation
on the exterior of the
hinged seal. Turn the energy saver switch OFF when
the environment
is warm and more humid or if
moisture
is noticed on the door exterior.
• On - This setting saves energy by not using the
heater. Turn the energy saver switch ON when the
environment
is less humid.
10
Advertisement
