Advertisement
Available languages
Available languages
Materials
Needed:
• '/4"outer diameter flexible copper tubing
• Shut-off
valve (requires
a '/4" hole to be drilled into
water supply line before valve attachment)
• Adjustable
wrench
• '/_" hex nut driver
Notes
• Use copper tubing
only for installation.
Plastic is
less durable and can cause damage.
• Add 8' to tubing length needed to reach water
supply for creation of sewice loop.
2_
3.
Create service loop with copper
2' diameter
tubing
(minimum
2' diameter),
minimum
Avoid kinks in the copper tubing
/_r_
when bending it into a service
loop. Do not use plastic tubing.
/_
Remove plastic cap from water valve inlet port.
o_o
Place brass nut (A) and sleeve (B) on
_
copper tube end as illustrated.
A
B
Renlinder:
Do not use an old
__
sleeve. The nut and sleeve are
provided in the use and care packet.
-::
_
4. Place end of copper tubing
into water
valve inlet port. Shape tubing slightly. Do
not kink - so that tubing feeds straight
into inlet port.
5. Slide brass nut over sleeve and screw nut
into inlet port. Tighten nut with wrench.
zi:°
iMPORTANT:
Do not overtighten.
Cross
threading
may occur.
Pull on tubing to confirm
connection
is
secure. Connect tubing to frame with
water tubing
clamp (C) and turn on
water supply. Check for leaks and
correct if necessary. Continue to
observe the water supply connection
for two to three hours prior to moving
the refrigerator
to its permanent
location.
............
i!ii!i!iii
7. Monitor water connection
for 24 hours. Correct
leaks, if necessary.
Opening and Closing Your
Fresh Food Doors
Your new refrigerator
is
uniquely designed with two
fresh food doors.
Either door
can be opened or closed
independently
of one another.
There is a vertically-hinged
section on the left fresh food
door. When the left door is
closed, the hinged section
automatically
forms a seal
between the two doors when
both doors are closed.
When the left door is opened,
the hinged seal automatically
folds inward so that it is
out of the way.
Advertisement
