Coil Cooktop; Cooktop; Surface Elements; Indicator Lights - Magic Chef TIME SAVOR RANGE Manual

COIL COOKTOP
Cooktop Indicator Lights
Freestandingrangeswitha coil-type cooktop will feature Rangesare equippedwithtwo indicator lightswhich glow
an "upswept" oooktop. The cooktop on a Canadian when a surface element is on. The indicator light will
freestanding range does NOT lift up. remain on until the element is turned off. After a cooking
operation, be sure the element and indicator light are off.
To raisethe "upswept" cooktop:When cool,graspthe
frontedge of the cooktopand gentlylift up untilthe two
supportrodsat the front of the cooktopsnap intoplace.
Drip Bowls
__ • Be sure drip bowls, located under each element, are
in place.
• Absence of these bowls during cooking may subject
wiring or component parts underneath the cooktop to
damage.
• To prevent risk of electric shock or fire, do not line drip
bowls with aluminum foil.
Tolowerthetop: Holdthefrontedgeofthe cooktopand Your range will be equippedwith eitherchromeplated
carefullypush back on each supportrodto release the steeldrip bowlsor porcelaincoatedsteel drip bowls,
notchedsupport.Then gentlylowerthe top into place.
The support rods willslide into the rangeframe. Chrome drip bowls will turn blue or gold over time if
overheated. This type of discoloration is permanent and
Surface Elements
will not affect the cooking performance.
• Surface elementsare self-cleaning. To protectthe porcelaincoated steelfinish, avoidusing
high settings for long periods of time. Reduce to a lower
• Do not immerse elements in water, setting once food begins cooking. Do not use oversized
• When an element is turned on, it will cycle on and off cookware. Pan should not extend more than 2 inches
to maintain the heat setting, from the element.
• To prevent damage tothe range, NEVER operate the Clean bowls after each use with soap and water.
surface element without a pan in place and NEVER Remove stubborn stains with baking soda paste and
allow a pan to boil dry. plastic scouring pad or a mild cleanser. To prevent
scratching the finish, do not use abrasive cleaning
andC°°l'T°and carefullyrem°Ve:awayraise fromelement pulIWhentheOut _,_ __ agents. Rinse, dry and replace.
receptacle.
To replace: Insert the terminals on the element into the
receptacle. Gently lift up on outer edge of element
(opposite terminal-side of element) while inserting
terminals into receptacle. Gently press down on outer
edge of element until element sits level on drip bowl.
Be sure drip bowl and chrome trim ring, if equipped, are
properly installed. The notch on the trim ring should be
centered over the screw securing the receptacle to the
maintop, if trim ring is not installed properly and rests on
this screw, the trim ring and drip bowl will "rock".
PAGE 10