Table of Contents
Advertisement
Available languages
Available languages
Useappropriate a nchors when fastening themounting bracket t oanymaterial
otherthanhard-wood o rmetal.
Prepare holesatfastener l ocations a sidentified below:
o
0
o
Figure 6: Mounting Anti-tip Bracket
Left
Cabinet
Wall Line
Floor
I 4-7/8" 14 from edge of range
f
.....
/7--
-I" \
t
Y///////_
Y////////
Front
Edge
of
_I
14
4=7/8"
_
__,_
RightCabinet
typical-
t _
either
side)
Mounting Anti-Tip Bracket
Figure 7: Placement of Anti=Tip Bracket (Top View)
For walls, wall studs, or floors composed of solid wood or metal, drill 1/8"
pilot holes.
For walls or floors composed of drywall, sheet-rock or other soft materials,
drill 3/16" holes to a minimum depth of 1-3/4", then tap plastic anchors into
each of the holes using a hammer.
For walls or floors composed of concrete or concrete block, drill 3/16" holes
to a minimum depth of 1-3/4", then tap concrete anchors into each of the
holes using a hammer.
For walls or floors havinq ceramic tile coverinq, drill 3/16" holes through the
tile only, then drill into the material behind the tile as indicated immediately
above.
If the range is moved to a new location, the Anti-Tip Device must be removed
and reinstalled.
The alternative floor mounted bracket shall be installed as follows:
1.
Place bracket on floor in position shown in Figure 7 (Bracket may be used in
either corner of the installation area).
2.
Secure to floor or wall stud.
3.
Later, when the unit is installed, the adjustable leg will slide under the bracket.
Page 14
Advertisement
Table of Contents
