Clearing Jams
Careful selection of appropriate print media and proper loading allow you to
avoid most jams. See "Print Media Guidelines" on page 189 for more
information.
NOTE:
Before buying large quantities of any print media, it is recommended that
you try a sample first.
Avoiding Jams
•
Use only recommended print media. See "Print Media Guidelines" on
page 189 for more information.
•
See "Loading Print Media in the Multipurpose Feeder (MPF)" on page 202
and "Loading Print Media in the Priority Sheet Inserter (PSI)" on page 211
to load print media properly.
•
Do not overload the print media sources. Ensure that the stack print
media height does not exceed the maximum height indicated by the load
line labels in the tray.
•
Do not load wrinkled, creased, damp, or curled print media.
•
Flex, fan, and straighten print media before you load it. If a jam occurs
with print media, try feeding one sheet at a time through the single sheet
feeder.
•
Do not use print media that you have cut or trimmed.
•
Do not mix print media sizes, weights, or types in the same print media
source.
•
Ensure that the recommended print side is face up when you insert the
print media. Also, the recommended print side should be face down when
using the single sheet feeder.
•
Keep print media stored in an acceptable environment. For more
information, see "Storing Print Media" on page 196.
•
Do not remove the feeding tray during a print job.
•
Push the tray in firmly after loading.
26
Clearing Jams
459