Adjust Altitude; Reset Defaults - Dell 1355 Color Laser User Manual

*1
This item is available only when Auto Registration Adjustment is set to Off.
*2
The color registration chart prints a lattice pattern of yellow, magenta, and cyan
lines. On the chart, find the values on the right side that are next to the line that is
perfectly straight for each of the three colors. If the value for this line is 0, color
registration is not needed. If the value for this line is any value other than 0, specify
the adjustment values under Color Registration Adjustment.

Adjust Altitude

Purpose:
To specify the altitude of the location where the printer is installed.
The discharge phenomenon for charging the photo conductor varies with
barometric pressure. Adjustments are performed by specifying the altitude of
the location where the printer is being used.
NOTE:
An incorrect altitude adjustment setting leads to poor printing quality,
incorrect indication of remaining toner.
Values:
0 meter*
1000 meters
2000 meters
3000 meters
Apply New Settings

Reset Defaults

Purpose:
To initialize NVM (non-volatile memory) for system parameters or Address
Book data. After executing this function and rebooting the printer, the menu
parameters or data are reset to their default values.
For details, see "Resetting Defaults" on page 357.
Values:
System Section
340
Understanding the Tool Box Menus
Specifies the altitude of the location where the printer
is installed.
After you complete the settings, press the Apply New
Settings button to apply the changes.
Click to initialize the system parameters.