Gsm7352S Rear Panel - NETGEAR GSM7352SNA - Prosafe 48 Port Gigabit L3 Managed Stackable Switch Installation Manual

Managed Stackable Layer 3 Switches GSM7328S, GSM7352S and GSM7328FS Hardware Instal-
Table 2-2. GSM7352S LED Description (continued)
LED
M1, M2, M3, M4
High-Speed I/O
Modules
(1 LED per
module)
SFP ports

GSM7352S Rear Panel

The rear panel has four module bays, a redundant power supply connector, a
console port, and a standard AC power receptacle for the supplied power cord.
The module bays support any combination of either the ProSafe 10-Gigabit
Ethernet XFP Adapter (AX741) or the ProSafe 24-Gigabit Stackable Module
(AX742). See "High-Speed I/O Module Bays" in Chapter 3.
Figure 2-4
2-6
Description
XFP Module present or Stacking Adapter present and ACT LED
XFP Module present LED /ACT
• Off: The 10GbE Adapter is not present.
• Solid green: The 10GbE Adapter is present.
• Blinking green: Packets transmission or reception is occurring on
the port.
Stacking Adapter Link/ACT LED
• Off: Stacking module is not present .
• Solid green: Stacking module is present .
• Blinking green: Packets transmission or reception is occurring on
the port.
• Link/ACT LED
• Off: No SFP module link is established on the port.
• Solid green: A valid SFP module link is established on the port.
• Blinking green: The port is sending or receiving packets.
Note: If port 41~48 media is changed to copper, the SFP LEDs
change to OFF status.
Stacking/XFP
module bays
v1.0, February 2007
Power receptacle
Redundant
power supply
connector
Console
Introduction