Introduction; Gsm7328S Front Panel And Leds - NETGEAR GSM7352SNA - Prosafe 48 Port Gigabit L3 Managed Stackable Switch Installation Manual

The NETGEAR Layer 3 Managed Stackable Fast Ethernet Switch is a state-of-
the-art, high-performance, IEEE-compliant network solution. It includes powerful
management features that you can use to eliminate bottlenecks, boost
performance, and increase productivity.
This guide describes hardware installation and basic troubleshooting for the
following NETGEAR switches:
• ProSafe™ 24-Port 10/100/1000 L3 managed Stackable Switch with 4 10
Gigabit I/O Slots GSM7328S
• ProSafe™ 48-Port 10/100/1000 L3 managed Stackable Switch with 4 10
Gigabit I/O Slots GSM7352S
• ProSafe™ 24 Fiber SFP Gigabit Layer 3 managed Stackable Switch with 4
10-Gigabit Slots GSM7328FS
These switches can be free-standing, or rack-mounted in a wiring closet or an
equipment room. For information about features for each product, see the
NETGEAR Web site at http://www.netgear.com.

GSM7328S Front Panel and LEDs

The following figure shows the front panel of the GSM7328S. The front panel
contains LEDs, a RST (reset) button, RJ-45 jacks, copper/fiber combo ports, and
two module bays.
The module bays support any combination of either the ProSafe 24-Gigabit
Stackable Module (AX742) or the ProSafe 10-Gigabit Ethernet XFP Adapter
(AX741). See "High-Speed I/O Module Bays" in Chapter 3.
v1.0, February 2007
Chapter 2

Introduction

2-1