Ioa Slot Combinations - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 MODULE GUIDE REV 01-10-2010 Manual

E120 and E320 11.3.x Module Guide
Table 28: Module Combinations (continued)
Modules
IOA Modules
ES2-S1 GE-4
ES2-S1 GE-8
ES2-S3 GE-20
ES2-S1 10GE
ES2-S2 10GE PR
ES2-S1 OC3-8 STM1 ATM
ES2-S1 OC12-2 STM4 ATM
ES2-S1 OC12-2 STM4 POS
ES2-S1 OC48 STM16 POS
ES2-S1 REDUND
ES2-S1 SERVICE

IOA Slot Combinations

74
ES2 4G LM ES2 10G UPLINK LM
√ –
√ –
– –
√ –
– √
√ –
√ –
√ –
√ –
√ √
√ –
Depending on the software release and IOA type, you must install IOAs in certain slots
and bays combined with other IOAs in the same slot:
You must insert some IOAs only in the upper bay or right bay (Adapter 0) of each IOA
module slot. If you insert one of these IOAs into a lower bay or left bay (Adapter 1) slot,
the line module diagnostics fail, an error message states that the bottom slot is not
supported for the currently installed software release, and the slot is disabled.
If you insert an unrecognized IOA, such as an IOA that is not supported by a particular
software release, the line module diagnostics fail, an error is generated, and the slot
is disabled.
If you remove an IOA and replace it with a different IOA in the same slot, an error
message states the mismatch and the slot is disabled.
Full-height IOAs take up the entire slot (both Adapter 0 and Adapter 1).
For information about working with modules and IOAs, see JunosE System Basics
Configuration Guide, Chapter 6, Managing Modules. See Table 29 on page 75 for currently
available IOAs and the bays in which you may insert them.
ES2 10G LM ES2 10G ADV LM
– –
√ √
√ √
– –
√ √
– –
– –
– –
– –
√ √
– –
Copyright © 2010, Juniper Networks, Inc.