Oc48/Stm16 Pos Ioa - Juniper E SERIES BROADBAND SERVICES ROUTERS 11.3.X - E120 AND E320 MODULE GUIDE REV 01-10-2010 Manual

OC48/STM16 POS IOA

IOA label
Number of IOA ports
Software release
Description
Capability
Software features
Model compatibility
Line module compatibility
SRP module compatibility
Line module redundancy
compatibility
Module redundancy support
Port redundancy support
Cables and connectors (single-mode
short reach [SR-1])
Copyright © 2010, Juniper Networks, Inc.
ES2-S1 OC48 STM16 POS IOA
1
First supported: 7.0.1
30 W maximum
Half-height module
See "Module and Slot Combinations" on page 73 for more information on
combining IOAs in a slot.
Unchannelized, concatenated OC48/STM16 for POS
OC48/STM16
HDLC framing
See "OCx/STMx POS IOAs" on page 66 for information about the layer 2 and layer
3 protocols and applications that this module combination supports.
E320 router
E120 router
ES2 4G LM
SRP-100
SRP-120
SRP-320
Can be paired with an ES2 4G LM.
Must be installed in the same redundancy group as an ES2 4G LM and ES2–S1
REDUND IOA combination.
Yes (Redundancy IOA must be installed in either slot 0 or slot 11)
Not applicable
Up to one LC full duplex connector
Transmit power:
min: –10 dBm
max: –3 dBm
Center wavelength: 1310 nm
Receive input power:
min: –18 dBm
max: –3 dBm
Rated for 2 km (1.2 miles) of 9-micron core cable
See E120 and E320 Hardware Guide, Chapter 5, Cabling the Router for more
information.
OC48/STM16 POS IOA
43